|
Install PerfMonitor
Unzip all files in the same directory and run perfmonitor.exe. You can run as many instances of PerfMonitor as there
are physical CPUs in your system (see below for the particular case of CPUs that use HyperThreading technology).
The first instance will be attached to CPU #0, the next one to CPU#1, and so on.
The application settings will be saved in a file named PerfMonX.ini (where X refers to the CPU number)
stored in your temporary account path (typically : C:\Documents and Settings\UserName\Local Settings\Temp).
Select monitored events
PerfMonitor allows to track up to 4 events, depending on the CPU model. Each event is attached to a graph.
In order to change the monitored event, put the mouse cursor on a graph then click on the left button to
make the events menu selection appear (note that the currently monitored event is checked in the menu).
Because of hardware limitations (namely the number of available counters), it is possible that all the desired
events can't be monitored in the same time than other events.
If a requested event is not available for monitoring, the graph will appear in grey color. Note that the events
are created from the top to the bottom, consequently the events on the top graphes have more chance to be
allocated. Note also that some events need two counters, especailly the ones that tracks a cache level success
rate.
If the change of an event frees a counter that allows a non-available event to be monitored, it will be
started automatically.
PerfMonitor and HyperThreading
In spite of the fact that CPUs that use HyperThreading are seen as two CPUs, the two units share the same
processor resource, and only one instance of PerfMonitor can be ran on these CPUs. However, it is possible
to monitor events on only one of the logical unit or on both. In order to select the monitored logical unit,
open the general settings menu (mouse right click) and select "HT Affinity".
Record results
The monitoring output can be stored in a txt file. The file is created in the same directory level as perfmonitor.exe
and uses the following name convention :
pmon_cpuX_MM_DD_HH_NN.txt, where :
- X is CPU number in the system (starting at 0).
- MM is month.
- DD is day.
- HH is hour.
- NN is minute.
To start recording, press F5. The application title bar will confirm that the events are being recorded.
Press F5 again to stop recording. Note that changing an event will cause the recording to be stopped.
The generated files can then be used in a spreadsheet to build curves and graphes. The graphic below shows
the L1 aand L2 caches success rate during the Cachemem "Memory Walk Test" on an Athlon 64 CPU.
|
